Ultra Low Current Driver for 12 volt High Flow Electric Remote Solenoid Shut Off Valve

Ultra Low Current Driver for 12 volt High Flow Electric Remote Solenoid Shut Off Valve
  • Click to enlarge
£50.11

Product Information
Specification

GAS IT Ultra Low Current Electronic Control Unit for a LPG vapour tank fitted with the GAS IT electric remote solenoid service valve ( no wiring, siwthces, sender or plugs included as this unit comes with screw termial connections ). 

If you have a GAS IT vapour tank with one of our 12 volt high flow electric remote solenoid shut off valves pre-fitted directly in the tank ( There will be no manual tap outlet fitted ) and you want to make sure the 12 volt electric remote solenoid shut off valve only draws the very minimum of current from your vehicles battery when the gas tank is open and in use ( to keep the 12 volt high flow electric remote solenoid shut off valves open to let gas out so you can run your gas appliances in the vehicle) and you don't weant to buy our complete pre wired ECU with switch and level sender, then the GAS IT Ultra Low current driver unit is the part for you.

When in use with your own separately purchased switch, this GAS IT Ultra Low Current Electronic Control Unit will reduce the standard high current consumption of the high flow solenoid ( which is normally in excess of 1.5 amps ) and drop it down to a very manageable Ultra Low Current which will extend your vehicles battery life when in use to months not just 10's of hours when the gas tank is in use to keep your gas fridge or gas appliances running.  Without this ultra Low Current Driver, the standard Solenoid will draw in excess of 1.5 amps which will flatten your vehicle battery in just a few hours. 

This GAS IT developed Ultra Low current driver has screw terminals for wiring up to and you will need some wiring skills and ability to follow a wiring diagram, plus connect it to your separately purchased switch or vehicle control panel and gas tank solenoid.install it.

Please note : This Electric Ultra Low Current Driver will not work with any other tank solenoid and is only designed to work with GAS IT's 12 volt high flow electric remote tank solenoid shut off valve, our part number : GI-VAL-V-027. The Ultra Low Current device must be fused with a 2 amp fuse when installed ( available separately )

To clarify : To use this GAS IT Ultra Low Current Electronic Control Unit you need a means of turning it on and off using a 12 volt negative switched supply. ( A switch or vehicle control panel ) It works by taking a negative switch signal from either your own supplied simple 2 pole switch or from your vehicles electric control panel or from one of the GAS IT switch range which we sell in the dedicated GAS IT Electronics & Controllers - Low Voltage category here on the webshop ( Click here to visit the Electronic catagory on our webshop ) .

We sell a complete kit to connect directly to the GAS IT tanks pre-fitted 12 volt high flow electric remote solenoid shut off valve which includes the GAS IT Switch, Electronics, Relay and sender in the GAS IT Electronics & Controllers - Low Voltage section on this webshop : Part Number GI-ELE-012

Any questions please do not hesitate to email or call our GAS IT Sales and Technical Team on sales@gasit.co.uk or Telephone 01286 832443

Product CodeGI-ELE-008
ManufacturerGAS IT
ConditionNew
Weight0.3kg


Customer Reviews

This product hasn't been reviewed yet.

Write a review

Write Review

Please enter a valid email address.
This field is required.
Top