GAS IT On Bottle Short Horizontal Fill Conversion Kit

GAS IT On Bottle Short Horizontal Fill Conversion Kit
  • Click to enlarge
  • Click to enlarge

(Quantity discounts available)

Product Information
Quantity Discounts

GAS IT On Bottle short horizontal fill conversion kit.

With UK horizontal fill bayonet, inlet & outlet blanking caps.

To use this kit you must fit the UK fill bayonet to the elbow, on the fill valve, no sealant should be required as they are a face fit. The fill bayonet in this kit is 640mm in length.

The blanking cap must be in place on the outlet whilst filling and on the inlet once filling has been completed.

If you remove a GAS IT bottle or GAS IT tank for any reason and want to store it for any length of time then this is the kit for you to make sure your bottle or tank is protected against potential leaks or damage of the threads.

This GAS IT kit comes with a 21.8LH blanking plug, with vitron seal, which screws on the outlet tap of your GAS IT bottle or GAS IT tank for that matter, and the other part is an brass cap which screws on and protect the threads of the filling bayonet.

Fitting is simple and uses normal hand tools.

‘ This part will not work with exchange gas bottles as they are designed for certified refillable bottles with Overfill Prevention Device ( OPD ) fitted which are TPED and Pi marked.’

Product CodeGI-FP-038
ManufacturerGAS IT

You can save money on this item when you purchase several at a time. The table below shows the minimum quantities required to benefit from this offer, and how much they'll cost.

QuantityPrice per unit

Customer Reviews

This product hasn't been reviewed yet.

Write a review

Write Review

Please enter a valid email address.
This field is required.