GAS IT Knowledgebase
GAS IT > GAS IT Technical Support Portal > GAS IT Knowledgebase

Search GAS IT Knowledgebase:


I've bought a new GAS IT bottle, what do I need to know and do first?

Solution

GAS IT Bottles shipped by courier & gauge functionality check before first fill up.

 

How to fit the mechanical gas level indicator to your GAS IT bottle, how to test the gauge is working and how to remove any air from inside the bottle - all before you pipe it up and before filling with LPG.

 

  Before installing the gas bottle into your vehicle you must fit the mechanical gas level indicator provided, it’s stapled to a flap in the bottle box, onto the neck of the GAS IT bottle as show in section A, B & C of the document you get provided inside your gas bottle box document pack. The same document is also attached as a downloadable document below should you need it.

Once you’ve fitted the gas level gauge to the bottle move onto the next procedure to show you that the gauge and float has been reset and is working before fitting the bottle into the vehicle and definitely before filling it up with LPG.

Once you have fitted the clip on gauge to the bottle, hold the bottle and gently rock it from side to side / up and down and this movement will show you that the gas level indicator and float system has been reset and is working correctly as the needle on the gauge will go from empty to full and back again ( see attached video ). 

When you are happy the gauge is working continue to install the gas bottle in your vehicle.

Do not fill with LPG before completing the previous and following steps first.

Once the install of your bottle and filling system is complete and before connecting the gas pigtail to the tap on the bottle, open the gas outlet tap slightly and release any air which has been left in the bottle.  Once the bottle is empty of all air, close the manual tap and reattach the pigtail to the gas bottles outlet tap before going to fill it with LPG/ Autogas.

If you are happy your gauge was working, if you're sure you have drained the air from the bottle and your sure you have connected all the pipes and hoses securely then now go to fill up with LPG.

Remember that once you have filled up your GAS IT bottle with LPG you should promptly check all connections with certified leak detection spray to make sure you have no leaks.  We always recommend retesting all joints and connections for leaks during the ownership of your GAS IT products as they might become loose due to vibrations when traveling.

If you have any questions contact our GAS IT technical support team at GAS IT HQ via the raise a support ticket on our knowledgebase.

We have a downloadable GAS IT Technical Article on this attached here that will offer some assistance.

Attachments:
E006A-GAS-IT-Bottle-Welcolme-Letter.pdf E006A-GAS-IT-Bottle-Welcolme-Letter.pdf
Quick-GAS-IT-Bottle-check-video.MOV Quick-GAS-IT-Bottle-check-video.MOV
LPG-fillpoint-Location-information-Doc-E004.pdf LPG-fillpoint-Location-information-Doc-E004.pdf

 
Was this article helpful? yes / no
Related articles I've bought a new GAS IT bottle, what do I need to know and do first?
My newly delivered gas bottle gauge isn't reading on my first fill up with gas.
LED and Contents Gauge Wiring
How accurately is my gas level indicator on my gas tank going to be?
Gas Level indicator accuracy questions.
Article details
Article ID: 83
Category: GAS IT Bottles
Rating (Votes): Article rated 3.7/5.0 (3)

 
« Go back